Bora PURA2R

Soften dried-on dirt rather than scraping it away.

1. 1

   Wipe the surfaces

   Use a soft, damp cloth with detergent or mild window cleaner on the extraction-system surfaces. Soften dried-on dirt with a damp cloth; do not scrape.

Weekly, or sooner: After very greasy cooking

Clean at least weekly, and sooner after very greasy cooking.

1. 1

   Lift out the parts

   Lift out the air inlet nozzle, then lift the stainless-steel grease filter by its handle.

   

   

The removable housing base is beneath the cooktop inside the floor unit.

1. 1

   Isolate the power

   Switch off, allow to cool and safely disconnect the appliance from the mains before opening covers near the fan.

2. 2

   Open and clean

   Remove the inlet nozzle, grease filter and filter-replacement cover. Release all six locks around the housing base and remove the base. Clean the housing and base with a mild cleaning agent.

   

Deal with spills and debris promptly to prevent marks and scratching.

1. 1

   Remove loose debris

   Remove crumbs, grains and similar debris immediately so they cannot scratch the surface. Wipe boiled-over food with a damp cloth.

2. 2

   Handle sticky spills

   Remove melted plastic, aluminium foil and sugar or sweet food from the hot cooking zone immediately with a glass-ceramic scraper. Take care around hot surfaces.

3. 3

   Clean the cooled glass

   Once cool, remove coarse residues with a glass-ceramic scraper. Spread suitable glass-ceramic cleaner with kitchen paper or a clean cloth, wipe with a damp cloth and dry with a clean cloth.

Remove dirt promptly so the touch controls remain clear.

1. 1

   Wipe gently

   On the switched-off, cooled appliance, wipe the controls with a lightly dampened soft cloth and a suitable non-abrasive cleaner. Keep liquid out of the appliance.

Replace the stainless-steel filter if cleaning no longer removes all dirt.

1. 1

   Fit the replacement

   Lift out the inlet nozzle and old filter using its handle. Put in a clean, dry replacement grease filter compatible with Pure 2, then refit the inlet nozzle.