Choose what you notice. These are the issues covered by your appliance guide.
Close the panel completely.
Order a replacement tank; do not keep using a leaking tank.
Contact Siemens service; the sensor may be faulty.
A hardness setting that is too low can cause this.
Wait until the cavity cools and the lock symbol disappears. Never force the door.
Press and hold the child-lock button for about four seconds until the lock is deactivated.
Check whether other kitchen appliances have power and the oven circuit breaker is in order. If the fault remains, contact Siemens service.
Let the cavity cool, then restart the selected function.
Switch the oven's circuit breaker off for about 10 seconds and on again. Switch the oven on and disable demonstration mode in Settings, then save.
Close the appliance door and press on/off.
Switch the oven off and on once. If the code returns, contact Siemens service with the exact code.
Condensation behind the panel can cause temporary flashing; it stops when the moisture evaporates.
An automatic heater can run to reduce condensation. The cavity and accessories may become hot. This is normal and does not affect cooking results.
Check power and the circuit breaker. If the panel still will not open, contact Siemens service.
If water remains in the tank, ask Siemens for help emptying it safely; do not force the panel.
Contact Siemens service. Never remove the lamp cover.
Keep ordinary cleaning to accessible surfaces and the seal in place. Ask Siemens for help with internal panes. Never loosen the four black door screws: microwave energy could escape. Do not operate with damaged glass or before complete correct reassembly.
Switch off, switch on and set the required function again. Set a cooking duration for long cooking to avoid an unintended automatic stop.
When the oven asks you to rinse
Switch on and follow the rinse prompt. Open the panel, remove and thoroughly rinse the tank, refill with water and reinsert it. Close the panel and press start/stop.
When prompted, repeat the tank rinse, refill, refit and start/stop sequence. Let the second rinse finish.
Empty and dry the tank and lid seal, let it dry with the lid off, refit it and switch off.